Services
Warehouse floor striping
Floor markings for warehouses, distribution centers, manufacturing floors and parking garages across Florida and South Georgia. We lay out and paint the lines that keep forklifts and people apart, and the work is done in sections so the building stays open.
What we mark
Lanes, walkways, zones and numbers
A floor plan only works if people can read it from a forklift seat. We restripe faded layouts and lay out new ones, from a single aisle to a full building.
Bring a drawing, a marked-up floor plan or just walk the floor with us. We measure, confirm the layout with you and put the scope in a written, itemized proposal.
What we mark
- Forklift lanes and travel aisles
- Pedestrian walkways and crossings
- Safety zones and hazard hatching
- Keep-clear boxes at exits, electrical panels and fire equipment
- Dock door and bay numbers
- Staging and storage outlines
- Aisle and rack markings
How it works
Striped in sections, so the building keeps running
A warehouse cannot stop for paint. We close one area at a time, so docks, aisles and pick paths stay open everywhere else. Tell us your shift times and busiest dock hours at the site visit.
We walk the floor
A free site visit. We measure, look at the floor surface and the old markings, and go over the layout with you.
You get it in writing
An itemized proposal with the scope and the price. Ask us to list the sections and the order they close in.
We work in sections
The floor is split into sections. Each one is cleared, prepared, striped and handed back before the next one closes.
We stripe and walk it
Lines, hatching, numbers and legends go down. Ask for a walk-through with us when the last section is done.
Why it matters
Clear lines do a lot of quiet work
Floor markings are simple safety equipment. They only work when they are sharp, consistent and where people expect them.
Forklifts and people stay apart
Marked travel lanes and walkways give drivers and people on foot their own space, and show where the two cross.
Exits and equipment stay clear
Hatched keep-clear boxes stop pallets from drifting in front of exits, electrical panels, extinguishers and machines.
Safety walks go easier
Fresh, readable markings support your safety walks and audits. Faded or missing lines are easy to fix before someone writes them up.
Product has a place
Staging outlines, bay numbers and rack labels tell every shift where things go, so aisles do not turn into storage.
Surface preparation
The floor has to be clean and dry
Floor paint sticks to concrete, not to what is sitting on it. Dust, oil, tire marks and moisture all get between the coating and the slab, and lines put down over them peel early.
That is why preparation comes before any paint. Each section is cleared, cleaned and checked dry before we lay out and stripe it. Sealed or polished floors need extra attention, so we look at the surface during the site visit and say so in the proposal.
Colors
Common floor marking colors
Most facilities follow a similar color pattern so that anyone walking in can read the floor. This is common practice, not law.
Your safety plan decides. If your company has a color standard, we paint to it. If a building already has a system in place, we match it so the floor reads the same from one end to the other.
- YellowAisles, traffic lanes and walkway edges.
- WhiteStorage, staging and equipment outlines.
- RedFire equipment and safety stops.
- HatchStriped boxes for hazards and areas that must stay clear.
Common practice only. Your safety plan, your insurer or your corporate standard may call for something different, and we follow it.
Parking garages
Garage decks are floors too
A parking garage is striped like a lot but behaves like a building: concrete decks, low light, tight turns and no good time to close.
We stripe stalls, arrows, crosswalks, stop bars and accessible spaces in garages, one level or one section at a time, so there is always a way in, a way out and somewhere to park.
Reserved, numbered and visitor stalls, word legends and no-parking hatching are part of the same visit. The deck has to be clean and dry first, the same as a warehouse floor.
Common questions
What facility managers ask us
Do we have to shut down the warehouse?
No. The floor is split into sections and done one at a time, so the rest of the building keeps working. Ask us to list the sections and their order in the proposal.
Which colors should we use?
Your safety plan decides. Yellow for aisles and traffic lanes, white for storage and equipment outlines and red for fire equipment and safety stops are common practice, and we paint to whatever standard you give us.
Can you restripe our existing layout or work from a drawing?
Both. We repaint faded layouts as they are, and we lay out new ones from your drawing or from a walk of the floor with you.
Are you insured to work inside our facility?
We are insured. A certificate of insurance is available on request.